Solution 02
Effluent treatment plants (ETP)
Effluent treatment for pharmaceutical, chemical, textile, food and engineering plants. We start from your inlet analysis and consent conditions, then size the physico-chemical, biological and tertiary stages against the parameters that actually bind you.
- Physico-chemical
- Biological
- Tertiary
Process and technologies
Physico-chemical
pH correction, coagulation and flocculation with CLOTMASTER and FLOCMASTER dosing to strip colour, oil and suspended load.
Biological
Aerobic or anaerobic stages sized to the biodegradable fraction; EXO-OXYGENATOR raises oxygen transfer where COD load is high.
Tertiary
Pressure sand and activated carbon filtration, then UF/RO where discharge norms or reuse targets demand it.
Sludge handling
Thickening plus filter press to reduce hazardous-sludge disposal volume and cost.
Typical performance
Inlet against outlet
Representative ranges from delivered plants. Guaranteed values are fixed against your own inlet analysis and consent conditions at proposal stage.
Industries served
- Pharmaceutical
- Chemical
- Textile
- Food processing
| Parameter | Inlet | Outlet |
|---|---|---|
| COD | 2,000–8,000 mg/L | < 250 mg/L |
| BOD | 800–3,000 mg/L | < 30 mg/L |
| TSS | 500–2,000 mg/L | < 100 mg/L |
| Oil & grease | 50–200 mg/L | < 10 mg/L |
Reference
Leachate treatment plant, Bhiwandi–Atkoli, Thane
High-COD, high-TDS landfill leachate treated to discharge norms on a constrained site. 400 KLD, inlet COD 6,000–8,000 mg/L brought below 250 mg/L at the outlet, commissioned 2024.
See all projectsOther systems
Sewage treatment plants (STP)
Municipal and township sewage treated to CPCB/MPCB discharge and reuse norms.
Zero liquid discharge (ZLD)
No effluent leaves the boundary — water returns to process, salts leave as solids.
RO & UF systems
Membrane trains sized for the feed you actually have, not the brochure case.
Request an assessment
Tell us your ETP requirement.
Give us the parameters you have — flow, COD, BOD, TDS, consent conditions — and an engineer responds with a treatment scheme, a footprint and an indicative cost. No obligation, no sales sequence.
- 01
Share your inlet data
Flow, COD, BOD, TDS, pH, consent conditions — whatever you have.
- 02
Engineer reviews within 24 h
A process engineer, not a sales rep, studies the parameters.
- 03
Receive scheme + estimate
Treatment train, footprint, indicative cost and next steps.
Start your assessment
All fields are reviewed by an engineer.
Typical response time: within 24 hours